操作步骤Operatingsteps

1.首先用胶纸封住上吸板和下吸板;

2板盖对齐边线放在合适位置,滚轮中间线位置压住板盖显示区的边线,用笔做个记号,方便盖板取放在下吸板同一位置;

3盖住下吸板的地方用镊子隔一个孔扎一个;

4. OCA胶对齐滚轮,滚轮一定要压到OCA胶边线上,OCA胶盖住上吸板的地方,保证吸力用镊子全部扎孔;

5. 插上电源线,打电源开关;

6. 盖板放在下吸板做记号的位置,打开真空开关;

7. 把OCA胶保护膜撕掉对准盖板,关闭真空开关;

8. 上吸板往下压,启动真空开关,

9. 吸住OCA胶后抬起吸板将保护膜撕掉;

10.吸板再往下压,按下启动键,关闭开关,覆膜完成。

1. First usethe tape to seal the up and down side suction plate ;

2. Put theglass on down suction plate edge position ,Let Machine roller can cover theedge of glass, then use pen make a mark ,for next operation can find the sameplace.

3. under theglass cover place ,use Sharp stuff make one hole between two holes;

4. OCA mustalignment the wheel ,Roller must be pressed onto the edges of OCA,The coverplace of up plate by OCA ,use the sharp stuff make holes completely;

5. plug thepower line ,turn on the Power switch;

6. put theglass to the same place as marked , turn on the vacuumswitch,clean the glass ;

7. tear offthe protect film of oca ,turn off the vacuum switch;

8. Press theup suction plate on down suction plate ,Turn on the vacuum switch ;

9. When OCA besuction ,Lift the up suction plate ,Then tear off another protect film of OCA;

10. press theup suction plate to under suction plate again ,turn on the start button ,after thatturn off start button,whole process finished。